Replace the left 220V Cooling Fan

1. Use a flat head pry knife, pry the cover in the "220V Cooling Fan" on rubber fins.
2. Unscrew the left side of the fan to the motherboard used to secure the three screws: While this is a red 5.0mm of T5 Torx, Orange While this is 4.4mm of T5 Torx, yellow While this is 3.9mm wide head of T5 Torx.
3. Connect the left "220V Cooling Fan" cable ZIF socket hinge plate pry off with a pointed knife. But pay attention only to set off the hinge plate, not the entire outlet are off to. At this point you can use a plastic knife to pry the fan wires separate from the motherboard, but we must be careful, because these wires firmly glued to the motherboard, be careful not to damage the "220V Cooling Fan" motherboard. After loose wires can put out a fan.